![]() |
| Ombersley car show 2026 |
Not updated this blog for a few years, how times fly when you are having fun in a Cobra!. We’ve done lots of events and summer car meets and the car always seems popular with old and young. Lost count of how many folks have sat in it or asked for an engine start!
![]() |
| Shelsley Walsh members day |
Here are some of the issues and changes made.
Fuel starvation and fuel pump reverse/isolation switch
Every so often, the car will cut out due to fuel supply. Just bowling along at moderate speed and the engine splutters and dies, usually in hot weather but sometimes in say, 20 degrees moderate. Probably happened 5 times in total. I put it down to fuel vaporisation. My Carter fuel pump sits to the rear of the engine bay near the gearbox and is accessible opening the bonnet. This is useful as it meant I could swap over the power cables and run the pump in reverse to purge the system then reconnect correctly to prime and started fine. This happened a couple of times over a few months and I couldn’t think of how to solve it entirely but did work out making the purge process easier by fitting a fuel pump switch on the dash. This enables me to reverse the polarity to the motor and isolate the motor when I have the ignition on but engine not running. If I get fuel starvation, I simply reverse the power for a few seconds, switch back on off we go. Plus I’ve now got a cool jet fighter missile launch switch on the dash.
New Steering Wheel
I fitted a cheap £50 steering wheel initially but always liked the look of the Motolita wooden rim. I finally got round to fitting one but sadly could not stretch to the Motolita at £3-400. I got this similar one from Car Builder Solutions for around £120. It’s not as nice but does the job.
Driveability
I’ve always had issues with the car being tricky to drive part-throttle, snatching through the transmission particularly at low speeds. I’ve tried advancing and retarding the ignition to varying benefit but have found it increasingly annoying and frustrating. The distributor was set up with the vacuum advance canister connected as recommended to the manifold vacuum port. As an experiment I removed and blanked off the connection and could not believe the difference. All the snatching disappeared and it was possible to drive at 30mph in 4th gear without constantly dipping the clutch. Any downsides? - exhaust manifolds definitely run hotter and you can feel the heat through the pedal box (header pipes run just behind the firewall). Apparently this is due to slower mixture burn at part or no throttle when the mixture is weak needing longer to completely combust, hence the reason for significantly advancing the ignition timing when idling or cruising. Without the advance, combustion can still be occurring when the exhaust valves open, thus making the manifold hotter. At higher rpm and full throttle, mechanical advance takes over as normal. I would say that the initial throttle response is less aggressive while you wait for the mechanical advance to build and may feel less responsive but - it’s so much nicer to drive and plenty quick enough. I read somewhere that fuel consumption is improved with vacuum advance but if you are worried about fuel consumption in a Cobra you have the wrong car!
When I get chance I plan to try connecting the vacuum advance to the ported connection on the carburettor. This moves the port above the throttle plates and reduces the advance when the throttle is closed. The choice of manifold or ported vacuum is a hotly contested topic on many US forums. I’ll find out!
Cooling changes
The header tank was originally positioned in the typical front location, which due to the bonnet droop means that it’s not really high enough to obtain a proper header function. I relocated the tank to fit at the rear of the engine bay so that the tank is positively at the highest point.



.jpg)







No comments:
Post a Comment